| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: mana: validate rx_req_idx to prevent out-of-bounds array access
In mana_hwc_rx_event_handler(), rx_req_idx is derived from
sge->address in DMA-coherent memory. In Confidential VMs
(SEV-SNP/TDX), this memory is shared unencrypted and HW can modify
WQE contents at any time. No bounds check exists on rx_req_idx,
which can lead to an out-of-bounds access into reqs[].
Add bounds check on rx_req_idx in mana_hwc_rx_event_handler() before
using it to index the reqs[] array. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: Check for underflow in xfrm_state_mtu
Leo Lin reported OOB write issue in esp component:
xfrm_state_mtu() returns u32 but performs its arithmetic in unsigned
modulo-2^32 space using an attacker-influenced "header_len + authsize +
net_adj" subtracted from a small "mtu" argument. A nobody user can
install an IPv4 ESP tunnel SA with a large authentication key
(XFRMA_ALG_AUTH_TRUNC, e.g. hmac(sha512), 64-byte key, 64-byte trunc),
configure a small interface MTU (68 bytes), and set XFRMA_TFCPAD to a
large value. When a single UDP datagram is then sent through the
tunnel, xfrm_state_mtu() underflows to a near-2^32 value, and
esp_output() consumes it as a signed int via:
padto = min(x->tfcpad, xfrm_state_mtu(x, mtu_cached))
esp.tfclen = padto - skb->len (assigned to int)
esp.tfclen ends up negative (e.g. -207). It is sign-extended to size_t
when passed to memset() inside esp_output_fill_trailer(), producing a
~16 EB write of zeroes at skb_tail_pointer(skb). KASAN logs it as
"Write of size 18446744073709551537 at addr ffff888...".
Check for underflow and return 1. This causes the sendmsg attempt to
fail with ENETUNREACH. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: core: Run queues for all non-SDEV_DEL devices from scsi_run_host_queues
While a SCSI host is in a recovery state, scsi_mq_requeue_cmd() will not
set the requeue list for a requeued command to be kicked in the future.
The expectation is a call to scsi_run_host_queues() will kick all SCSI
devices once the recovery state is cleared.
However, scsi_run_host_queues() uses shost_for_each_device() which uses
scsi_device_get() and so will ignore devices in a partially removed
state like SDEV_CANCEL. But these devices may also have requeued
requests, leaving their requests stuck from not being kicked and causing
the removal process of the device to hang.
scsi_run_host_queues() needs to run against more devices than the macro
shost_for_each_device() allows. Instead of using the too limiting
scsi_device_get() state checks, only ignore devices in SDEV_DEL state or
when unable to acquire a reference. Attempt to run the queues for all
other devices when scsi_run_host_queues() is called. |
| The device log component of Fanvil x7a firmware version 2.6.0.1182 does not properly sanitize or encode reflected user supplied data. The lack of sanitization allows for the injection of HTML which can be used to execute malicious JavaScript code on any target browser which renders the device log component. |
| Netpbm through 11.16.00 contains a heap out-of-bounds write vulnerability in the rasttopnm Sun rasterfile run-length decoder pr_load_image in converter/other/rast.c. Attackers can supply a byte-encoded rasterfile with tiny dimensions and a long run-length body to write controlled bytes past md_image, causing memory corruption and crashes. |
| Schism Tracker through 20260524 contains a heap out-of-bounds write vulnerability in fmt_ult_load_song() in fmt/ult.c that fails to clamp the one-byte sample count to MAX_SAMPLES. Attackers can supply a crafted .ult module that overwrites the instruments pointer array, causing csf_destroy() to free attacker-chosen pointers and crash the application. |
| An issue was discovered on Tektronix 3 Series MDO devices before 1.21.1. An OS command injection vulnerability exists in the FILESystem:MOUNT:DRIve SCPI command handler. Insufficient neutralization of user-supplied input allows remote attackers to execute arbitrary operating system commands with elevated privileges. |
| Uncontrolled recursion in the SVG parser and renderer of the Qt SVG module (QtSvg) in Qt Group Qt allows attackers to cause a denial of service (application crash via stack exhaustion) via a crafted SVG file with deeply nested elements. |
| When semop(2) blocks waiting for a semaphore condition, it releases the per-set lock and sleeps. Upon waking, it checks the sequence number embedded in the semaphore set's IPC identifier to detect whether the set was removed while the caller was asleep. This sequence number is only 15 bits wide. If enough semaphore sets are created and destroyed in the same table slot while a caller is blocked, the counter wraps around, and semop(2) may falsely conclude that the original set still exists. The subsequent access to a semaphore within the set may then be out of bounds.
An unprivileged local user can trigger an out-of-bounds access on kernel heap memory, potentially leading to privilege escalation. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| ProPhoenix Law RMS v2022.2403.3.101 was discovered to contain a reflected cross-site scripting (XSS) vulnerability via the PageTitle/Alert/MsgType parameter in the errorHandler.aspx endpoint. |
| In the Linux kernel, the following vulnerability has been resolved:
vxlan: mdb: Fix source list corruption on a failed replace
When replacing the source list of an MDB remote entry, all existing
sources are first marked for deletion and vxlan_mdb_remote_srcs_add()
is then called to add the new source list. Sources present in the new
list have their deletion mark cleared, and any sources left marked
afterwards are removed.
If vxlan_mdb_remote_srcs_add() fails partway through, its error path
deletes all entries on the remote's source list. That rollback is only
correct for its other caller, vxlan_mdb_remote_add(), where the remote
was just allocated and the list contains solely entries added during
the call. On the replace path the list also holds pre-existing sources,
so a failed replace tears them down together with their (S, G)
forwarding entries instead of leaving the entry unchanged.
This is reachable from an existing (*, G) remote. An EXCLUDE filter
that loses sources starts forwarding traffic that should be blocked,
while an INCLUDE filter that loses sources drops traffic that should be
forwarded.
Mark entries created during the current pass with a new
VXLAN_SGRP_F_NEW flag. On failure, delete only those entries and clear
the deletion mark on the pre-existing ones, so a failed replace leaves
the source list untouched. Retain the flag until the whole operation
succeeds and then clear it. Also stop vxlan_mdb_remote_src_add() from
deleting a pre-existing entry it only looked up when adding that
entry's forwarding entry fails. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Substance3D - Stager is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| AIOHTTP is an asynchronous HTTP client/server framework for asyncio and Python. Prior to 3.14.4, keepalive timeout handling is absent during the initial portion of a request. An attacker can keep an idle connection open indefinitely before sending any request data, consuming server connection capacity. This issue is fixed in version 3.14.4. |
